Canon CXDI-50C Service Manual page 69

-L sessionLabel
Film session label
(character string)
-f films
Number of film box to be
printed
–i Format
Format at print
-l FilmSizeID
Film size
14 inch x 17 inch / 17 inch
x 14 inch / 11 inch x 14
inch / -l FilmSizeID / 10
inch x 14 inch
10 inch x 12 inch / 24 cm
x 24 cm / 24 cm x 30 cm
-M magnification
Interpolation method
(NONE/REPLICATE/BIL
INEAR/CUBIC)
-m smoothing
Type of smoothing
(character string)
2. Installation Manual
* This parameter is used in the
DICOM Basic Film Session
(2000, 0050).
* The label for the film session
is for designation purposes
only, and generally it is not
displayed directly on the
print image.
* Currently, this parameter is
not operating.
* This parameter is used in the
DICOM Basic Film Box
(2010, 0010).
* This is not necessary, as for
automatically designated on
CXDI.
* This parameter is used in the
DICOM Basic Film Box
(2010, 0050).
* This parameter designates
the size of the film to be
printed
* This parameter is used in the
DICOM Basic Film Box
(2010, 0060).
* This parameter designates
the interpolation method
since the printer has a higher
resolution than the CXDI in
most cases.
* Generally, CUBIC provides
the best results, followed by
BILINEAR. The
REPLICATE option is not
suitable for CXDI image
applications.
* This parameter is used in the
DICOM Basic Film Box
(2010, 0080).
* This parameter designates
the smoothing method for
the image.
* In the DICOM standards,
this parameter setting is
valid only when CUBIC is
selected for the
magnification parameter
above.
* In the DICOM standards,
value to be transferred is not
predetermined.
- 52 -
The parameter is not transferred over
DICOM if it is not designated.
* This parameter may be displayed in
some form or another depending on the
installed printer. For example, it may be
displayed in the Control Panel for the
printer or in the corner of the film.
* If this parameter is not designated,
transfer software uses automatically
STANDARD1 1, for reason this
parameter must be transferred in the
DICOM.
The parameter is not transferred over
DICOM if it is not designated. In this
case, the printer default values are used.
When this parameter is not transferred,
problems can occur since unsuitable
default values may be used.
* Some printers do not print until a supply
magazine of the designated size is
loaded, and others print even though the
designated size is different from the
currently loaded supply magazine.
The printer default values are used if
this parameter is not entered. When this
parameter is not transferred, problems can
occur since unsuitable default values may
be used.
The parameter is not transferred over
DICOM if it is not designated. In this
case, the printer default values are used.
When this parameter is not transferred,
problems can occur since unsuitable
default values may be used.
* This parameter is determined by asking
the printer engineer or by viewing the
conformance statement.