Canon CXDI-50C Service Manual page 148

(7) Tightening cable clamp plate screw 2
With the cable clamp inclined as shown above, gradually tighten the screw until there is
no space between the cable clamp plate and the cover, and that the space between the
outer side cable clamp plate and the cover is about 2.5 mm.
0mm
‚ O ‚ ‚
(8) Attaching jib B
Insert jig B between the outer side of the cable clamp plate and the cover. Tighten the
outer side screw while pressing jib B in the direction as illustrated.
U-groove
Technical information
Pushing in the cable with Jig B will decrease the amount of cable that will be caught in the
cable clamp plate. Jig B should be pushed until the U-groove touches against the screw.
4. Repair Guide
Jig B
13
2.5mm
‚ Q D ‚ T ‚ ‚