Status; Using The Status Function - YASKAWA MP900 Series User Manual

6.3 Status

The status function reports, in online, the 260IF Module DeviceNet address, baud rate setting,
and communications status.

6.3.1 Using the Status Function

The status is displayed using the following procedure.
1. Display the Module Configuration Window on the CP-717.
2. Double-click the slot to which the 260IF Module is set and open the 260IF Module Con-
3. Select the Status Tab in the 260IF Definition Window to display the Status Window.
MAC ID
Baud Rate
Status
www.dadehpardazan.ir 88594014-15
figuration Window.
Display Item
The MAC ID (DeviceNet address) set for the 260IF Module.
The baud rate set for the 260IF Module.
The 260IF Module status code. The contents of the display are shown
in the following diagram.
F E D C B A 9 8 7 6 5 4 3 2 1 0
6-7
Contents
Bit
Status code
02H: Checking for duplicate MAC IDs
Not used 04H: Online
08H: Bus-off detected
10H: Duplicate MAC ID
40H: Network power error
40H:Communications power error
Fatal error (Bus-off, duplicate MAC ID, network
Fatal error (Bus-off, duplicate MAC ID, communica-
power disconnected)
tions power disconnected)
Communications not ready or I/O allocations not set
I/O communications error
I/O communications normal
6.3 Status
6