260If Module Setup; Opening The 260If Module Configuration Window - YASKAWA MP900 Series User Manual

System Startup and Setup

4.3.1 Opening the 260IF Module Configuration Window

4.3 260IF Module Setup

4.3.1 Opening the 260IF Module Configuration Window

4
Rack 1
No
No
Module
Controller CPU No.
I/O Start register
I/O End register
The 260IF Module is set up from the CP-717 Engineering Tool.
1. Double-click the Module Configuration Definition Box for the Controller mounted to
the 260IF Module to display the Module Configuration Window.
Rack 1
No
No
Module
Controller CPU No.
I/O Start register
I/O End register
Fig 4.4 MP920 Module Configuration Window
・・・ ・・・ ・・・
00 01
MP920 RESERVED
MP920 RESERVED
・
・ ・・・ ・・・
・
・・・ ・・・
・・・ ・・・
・
・・・ ・・・
・
Fig 4.5 MP940 Module Configuration Window
For the MP920, set the 260IF Module for the slot in which the 260IF Module is
mounted. In the above example showing the MP920 Module Configuration Window, the
260IF Module is set in slot 02.
For the MP940, the 260IF Module is always in slot 06, but 260IF Module must still be
set.
The leading and end I/O register numbers must be set for the 260IF Module. Allocate I/
O registers within the ranges shown in the following table.
Leading I/O register
(Offset of leading IW/OW register)
End I/O register
(Offset of end IW/OW register)
2. Double-click the slot where the 260IF Module is set and open the 260IF Definition Win-
dow.
www.dadehpardazan.ir 88594014-15
1 ・・・ ・・・ ・・・
00
MP920
RESERVED
MP920 RESERVED
・
・ ・・・
・
・・・
・・・
・
・・・
・
02 03 04
SERIAL LIO SVA
SERIAL LIO SVA
・・・ ・・・ ・・・
・・・ ・・・ ・・・
・・・ ・・・ ・・・
・・・ ・・・ ・・・
MP920
0000 to 13FF
0000 to 13FF
4-10
01 02
260IF
260IF
・・・ ・・・
・・・ ・・・
・・・ ・・・
・・・ ・・・
05 06
CNTR 260IF
CNTR 260IF
・・・ ・・・
・・・ ・・・
・・・ ・・・
・・・ ・・・
MP940D
0000 to 07FF
0000 to 07FF