Flashforge Invertor II User Manual page 54

Step 2: Choose corresponding printer type and firmware version and click [OK] in the
firmware updating box. After confirming the printer is in free state, the software will
automatically update the firmware.
6-22
Step 3：Reboot you Inventor Ⅱ and wait for 4-5 seconds, then you can see the update
process bar. When the update finishes, it will go back to the main interface.
Step 4：Tap [Tools]--[About]
to check whether the updated version is right.
③ On Board Preferences
[Tools]--[On Board
When the computer and printer are in connection, click
Preferences], you can check the printer name.
④ Machine information
[Tools]--[Machine
When the computer and printer are in connection state, click
information], you can check the machine type, machine name and firmware etc.
54
InventorⅡ User Guide | www.flashforge.com 400-699-1063