Chapter 4 . Hardware Assembly; Mounting The Extruder Set - Flashforge Dreamer User Manual

Chapter 4 . Hardware Assembly

The Dreamer comes pre-assembled and is almost ready-to-print (ARP). All you need
to do is to mount the extruder set, and install the filament. It will only take 5 to 10
minutes to start up the Dreamer and prepare for your first 3D print!

4.1 Mounting the Extruder Set

4-1
(4-1) Lay the extruder module on the top of the extruder support with the two extruder
fans facing the front.
4-2
(4-2) Fix the extruder module onto the extruder support with two M3x12 screws from
the bottom up.
Dreamer User Guide | www.FlashForge.com 400- 699-1063
17