Table of Contents
Advertisement
Chapter 2: Entering Debugger Commands
Using the Command Line with the Mouse
To edit the command line using the command line
pop-up menu
• To clear the command line: position the mouse pointer within the Command
Line entry area; press and hold the right mouse button until the Command
Line pop-up menu appears; choose Clear Entire Line from the menu.
• To clear the command line from the cursor position to the end of the line:
position the mouse pointer at the place where you want the clear-to-end to
start; press and hold the right mouse button until the Command Line pop-up
menu appears; choose Clear to End of Line from the menu.
• To position the cursor at the next token or the previous token: press and hold
the right mouse button until the Command Line pop-up menu appears;
choose Forward Tab or Backward Tab from the menu.
When the cursor arrives at the beginning of a command word or token, the
softkey labels change to display the possible choices at that level of the
command.
See "To edit the command line using the mouse and the command line
pushbuttons" and "To edit the command line using the keyboard" for
information about additional editing operations you can perform.
To recall commands
1 Click the pushbutton labeled Recall in the Command Line to display the
dialog box.
2 Choose a command from the buffer list. (You can also enter a command
directly into the text entry area of the dialog box.)
Because all command entry methods in the interface — menus, action keys,
and command line entries — are echoed to the command line entry area, the
60
Advertisement
Table of Contents
