Table of Contents
Advertisement
Chapter 9: Debugger Commands
Debugger Option View
Stdio_Window
The Stdio_Window option controls the display of the Stdio window.
The Swap setting causes the Stdio window to be displayed when a program
writes to it and to be removed when the program returns to the command
mode.
The On setting causes the Stdio window to be displayed at all times. The
window may be hidden by other windows but will be displayed when a program
is writing to it.
If the oFF setting is selected, the window is not automatically displayed. You
must press function key F6 or enter the command Window Screen_On
Stdio to display the window.
The default setting is Swap.
Amt_Scroll
The Amt_Scroll option controls the amount that the Journal and Stdio
windows are scrolled when written to. When the output reaches the bottom of
the window, the data scrolls up one line by default. You can specify a number
of lines from one to 50.
Examples
To set the Swap option so that the Breakpoint window is displayed only when
the Window Active Breakpoint command is executed:
Debugger Option View Breakpt_Window Swap
To set the View_Window option so that the view window is always displayed:
Debugger Option View View_Window On
304
Advertisement
Table of Contents
