This is a message from the emulator which was not processed by the debugger.
All available information is displayed on the screen. Any one of a number of
notice messages may be displayed on your screen.
Miscellaneous fatal error.
All available fatal error information is displayed on the screen. The debugger
will then quit.
Too many interrupts pending.
Too many Program Interrupt commands have been given without a sufficient
number of interrupts being processed. The current limit on pending interrupts
Voids have no value.
This error message is returned when certain commands are attempted on voids.
This suboption does not work with this command. Refer to the "Debugger
Commands" chapter of this manual for valid suboptions for various commands.
This option does not work with this command. Refer to the "Debugger
Commands" chapter of this manual for valid options for various commands.
No temporary breakpoints for the macro.
The command Program Run From < addr> ;< macro> will return this error
because a temporary breakpoint has not been specified.
Invalid type for this argument, expecting a target address.
The command was expecting an address. Re-enter the command with a target
Chapter 12: Debugger Error Messages