To Reset Program Variables - HP 68000 Series User Manual

• Using the command line, enter:
Program Pc_Reset
And press the < Return> key.
The program counter is reset to the transfer address of your absolute file. The
next Program Run or Program Step command entered without a from address
will restart program execution at the beginning of the program.

To reset program variables

• Reload your program.
Memory is not reinitialized when you reset the processor or reset the program
counter. Therefore, program variables are not reset to their original values.
To reset program variables after resetting the processor or program counter,
reload your program.
For faster loading, you can load only the program code. The debugger retains
symbol information. You do not have to reload symbol information if symbol
addresses have not changed.
For information on loading programs, refer to the previous "Loading
Programs and Symbols" section.
Chapter 3: Loading and Executing Programs
Restarting Programs
103