Table of Contents
Advertisement
Chapter 9: Debugger Commands
Debugger Option View
Breakpt_Window
The Breakpt_Window option controls the display of the breakpoint window.
The On setting causes the Breakpoint window to be displayed at all times. The
window may be hidden by other windows but will be displayed whenever a
breakpoint is set or deleted.
If you specify the Swap setting, the window is not automatically displayed.
You must set or delete a breakpoint or enter the Window Active Breakpoint
command to display the window. The default setting is Swap .
View_Window
The View_Window option controls the display of the view window.
The On setting causes the View window to be displayed at all times. The
window may be hidden by other windows but will be displayed whenever a
Debugger Execution Display_Status command is executed.
If you specify the Swap setting, the window is not automatically displayed.
You must enter the Debugger Execution Display_Status command or the
Window Active View command to display the window. The default setting is
Swap .
Highlight
The Highlight option determines whether highlighted information in
debugger windows is displayed in half-bright video or inverse video. The
default is Inverse.
More
The More option controls how information resulting from a debugger
command is listed to the Journal window.
If the More option is On , information is listed one screen at a time in the
Journal window, in the same way as the more command in the Unix operating
system works.
If the More option is oFF , all information resulting from a debugger command
is written to the display at once, making it difficult to view information greater
than the number of lines available in the Journal window. The default setting
is On .
303
Advertisement
Table of Contents
