Table of Contents
Advertisement
Chapter 1: Getting Started with the Graphical Interface
To prepare to run the debugger
To prepare to run the debugger
1 Check that the debugger has been installed on your computer. Installation is
described in the "Installation" chapter.
2 Find out where the debugger software is installed. If it is not installed under
"/usr/hp64000" then use "$HP64000" wherever "/usr/hp64000" is printed in this
chapter.
3 Check that "/usr/hp64000/bin" and "." are in your $PATH environment
variable. (Type "echo $PATH" to see the value of $PATH.)
4 If the debugger software is installed on a different kind of computer than the
computer you are using, edit the "platformScheme" in the Xdefaults.sim file.
This file is located in directory /usr/hp64000/demo/debug_env/sim68000. For
example, if you are sitting at a Sun workstation which is networked to an HP
9000 Series 300 workstation, change the platformScheme to "SunOS".
12
Advertisement
Table of Contents
