Table of Contents
Advertisement
Chapter 14: Installation
To verify the software installation
To verify the software installation
A number of new filesets were installed on your system during the software
installation process. This step assumes that you chose to load the filesets for
the debugger/simulator's graphical interface.
You can use this step to further verify that the filesets necessary to successfully
start the graphical interface have been loaded and that customize scripts have
run correctly. Of course, the update process gives you mechanisms for
verifying installation, but these checks can help to double-check the install
process.
1 Verify the existence of the HP64_Debug file in the
$HP64000/lib/X11/app-defaults subdirectory by entering
ls $HP64000/lib/X11/app-defaults/HP64_Debug
at the HP-UX prompt.
Finding this file verifies that you loaded the correct fileset and also verifies
that the customize scripts executed because this file is created from other files
during the customize process.
2 Examine $HP64000/lib/X11/app-defaults/HP64_Debug near the end of the file
to confirm that there are resources specific to your microprocessor.
Near the end of the file, there will be resource strings that contain references
to specific microprocessors. For example, if you installed the debugger
graphical interface for the 68000 series microprocessors, resource name strings
will have "debug*m68000" embedded in them.
524
Advertisement
Table of Contents
