Table of Contents
Advertisement
Chapter 9: Debugger Commands
Memory Unload_BBA
Memory Unload_BBA
Note
You must have the HP Branch Validator product for the processor you are
debugging code for installed on your system in order to use this command. If
you do not have the HP Branch Validator for your processor, the debugger
will display the following error message when you attempt to execute this
command:
error code = 141
No valid BBA spec file for <processor> processor
The Memory Unload_BBA command unloads basis branch analysis (BBA)
information from program memory. The BBA preprocessor (-b option) must
be used at compile time in order for this information to exist in program
memory. The file name bbadump.data is the default dump file name.
Once this information has been unloaded, it can be formatted with the BBA
report generator, bbarep (see the HP Branch Validator for AxL S C User's
Guide).
Note
The Unload_BBA command is disabled when the debugger option
Demand_Load is On. If Demand_Load is oFF but the program was loaded
with Demand_Load On, the Memory Unload_BBA command will generate a
BBA file with incomplete information. See the Debugger Option General
command description in this manual for more information on the
Demand_Load option.
366
Advertisement
Table of Contents
