Table of Contents
Advertisement
Chapter 1: Getting Started with the Graphical Interface
To run until the breakpoint
To run until the breakpoint
• Click on the Run Xfer action key to run the program from its transfer address.
While the program is executing, the menus and buttons are "grayed out," and
an "hourglass" mouse pointer is displayed. You cannot enter debugger
commands while the program is executing. If you need to stop an executing
program, type < Ctrl> -C with the mouse pointer in the debugger X window.
After a few moments, line 42 will be highlighted, showing that program
execution stopped there.
The Journal window shows that a break occurred and which breakpoint it was.
21
Advertisement
Table of Contents
