Table of Contents
Advertisement
Chapter 3: Loading and Executing Programs
Using simulator and emulator debugger products together
Using simulator and emulator debugger products
together
You can continue a debugging session started in the debugger/simulator in the
debugger/emulator by following the steps listed below:
1 In the debugger/simulator, use the Debugger Execution Save_State
command to save the current memory contents and register values.
2 Quit the simulator session using the Debugger Quit command.
3 Start the debugger/emulator.
4 Load the state file created with the Debugger Execution Save_State
command using the Debugger Execution Load_State command. This
will restore memory and processor registers to the state you saved in the
debugger/simulator.
116
Advertisement
Table of Contents
