Figure 2-8 Sensor (Average Path) Functional Test Setup With - Keysight Technologies E4417A Service Manual

4 Zero the instrument:
5 Press
6 Connect the 30 dB attenuator as shown in
Figure 2-8
7 Turn on the power reference:
8 Switch to the power sensor's lower range:
9 Verify that the display reads −30 dBm ±1 dB. Record the reading in
Keysight E4416A/E4417A Power Meters Service Guide
Zero
Press , Zero . Wait approximately 25 seconds for the
Cal
wait symbol to disappear.
Cal to calibrate the power meter.
Power Meter
CHANNEL A
Sensor (Average Path) Functional Test Setup With Attenuator
Zero
Press ,
Power Ref On
Cal
– Press Channel .
– Scroll through the Range values by pressing
LOWER.
– A pop-up window is displayed.
– Press Done .
Figure
Power Sensor
30 dB attenuator
Power sensor cable
Performance Tests
2-8.
Change . Select a value of
Table
2
2-6.
55