Installing Options/Accessories; Headrest Supports (Multifunctional Seating Unit); Headrest Supports - Otto Bock Kimba neo Instructions For Use Manual

Attaching the seat (multifunctional seating unit)
INFORMATION
The product can also be equipped with alternative seating systems. In this case, please observe the information in
the separate instructions for use for the seating system.
1) Set the seat onto the rear tube of the seat adapter at an angle of approximately 45°.
2) Press the front edge of the seat onto the mobility base until the clutch audibly snaps into the front tube of the
seat adapter.
3) Slide the seat lock to the left to close it (see Fig. 2).
Attaching the padding (multifunctional seating unit)
INFORMATION
► Mount the pads before installing the standard padding.
► Prior to the assembly of the padding, adjust the seating unit (see chapter "Adjustments").
1) Open the zipper on the backrest padding.
2) Pull the back padding with its cap over the back insert and close the zipper (see Fig. 3).
3) Pull the excess back padding down between the lower edge of the back and the seat and attach it to the twist
locks on the outside of the back.
4) Place the seat cushion on the seat in such a way that the corresponding velcro/fleece surfaces can be connec­
ted (see Fig. 4).

5.2 Installing options/accessories

5.2.1 Headrest supports (multifunctional seating unit)

5.2.1.1 Headrest supports

1) Pull the proper sides of the headrest supports through the padding (see Fig. 5).
2) Open the zipper of the padding cap (see Fig. 3) and push the padding behind the seat to the side.
Kimba neo
1
3
Preparation for Use
2
4
Ottobock | 9