GE G60 Instruction Manual page 106
Generator protection system
Hide thumbs
Also See for G60:
- Instruction manual (780 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (768 pages)
Table of Contents
Advertisement
ADD DEVICE TO SOFTWARE
If using a blue or grey Ethernet cable, skip the rest of the this section. If using an orange cross-over Ethernet cable, the
computer needs to be set up as follows.
1.
Use an orange Ethernet cross-over cable to connect the computer to the rear Ethernet port. In case you need it, the
following figure shows the pinout for an Ethernet cross-over cable.
3
Next, assign the computer an IP address compatible with the relay's IP address.
1.
From the Windows desktop, right-click the My Network Places icon and select Properties to open the network
connections window. Or in Windows 7, access the Network and Sharing Center in the Control Panel.
3-50
Figure 3-58: Ethernet cross-over cable PIN layout
G60 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INSTALLATION
Advertisement
Table of Contents
