CHAPTER 6: ACTUAL VALUES
This menu allows the user to view the number of triggers involved and number of oscillography traces available. The cycles
per record value is calculated to account for the fixed amount of data storage for oscillography. See the Oscillography
section of chapter 5 for details.
A trigger can be forced here at any time by setting "Yes" to the FORCE TRIGGER? command. See the
menu for information on clearing the oscillography records.
RECORDS
6.5.4 Data logger
ACTUAL VALUES RECORDS DATA LOGGER
DATA LOGGER
The
represents the time at which the oldest available samples were taken. It is static until the log gets
OLDEST SAMPLE TIME
full, at which time it starts counting at the defined sampling rate.
The
represents the time the most recent samples were taken. It counts up at the defined sampling
NEWEST SAMPLE TIME
rate. If the data logger channels are defined, then both values are static.
See the
COMMANDS CLEAR RECORDS
6.5.5 Phasor Measurement Unit records
ACTUAL VALUES RECORDS PMU RECORDS
PMU
RECORDS
The number of triggers applicable to the Phasor Measurement Unit recorder is indicated by the
The status of the phasor measurement unit recorder is indicated as follows.
ACTUAL VALUES RECORDS PMU RECORDS PMU 1 RECORDING
PMU 1
RECORDING
6.6 Product information
6.6.1 Model information
ACTUAL VALUES PRODUCT INFO MODEL INFORMATION
MODEL INFORMATION
G60 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
OLDEST SAMPLE TIME:
2000/01/14 13:45:51
NEWEST SAMPLE TIME:
2000/01/14 15:21:19
menu for clearing data logger records.
NUMBER OF TRIGGERS:
0
PMU 1
RECORDING
PMU 1 FORCE TRIGGER:
Yes
PUM 1 AVAILABLE
RECORDS: 0
PUM 1 SECONDS
PER RECORD: 0.0
PUM 1 LAST CLEARED:
2013/07/14 15:40:16
ORDER CODE LINE 1:
G60-A00-AAA-A0A-A0A-
PRODUCT INFORMATION
COMMANDS CLEAR
Range: 0 to 65535 in steps of 1
See below
NUMBER OF TRIGGERS
Range: No, Yes
Range: 0 to 65535 in steps of 1
Range: 0 to 6553.5 in steps of 0.1
Range: YYYY/MM/DD HH:MM:SS
Range: standard GE order code format
6
value.
6-31