Control Pushbuttons - GE G60 Instruction Manual

PRODUCT SETUP
All major self-test alarms are reported automatically with their corresponding FlexLogic operands, events, and targets.
Most of the minor alarms can be disabled if so wanted.
When in the Disabled mode, minor alarms do not assert a FlexLogic operand, write to the event recorder, or display target
messages. Moreover, they do not trigger the ANY MINOR ALARM or ANY SELF-TEST messages. When in Enabled mode,
minor alarms continue to function along with other major and minor alarms. See the Relay Self-tests section in chapter 7
for information on major and minor self-test alarms.

5.3.13 Control pushbuttons

SETTINGS  PRODUCT SETUP  CONTROL PUSHBUTTONS  CONTROL PUSHBUTTON 1(7)
 CONTROL
 PUSHBUTTON 1
There are three standard control pushbuttons, labeled USER 1, USER 2, and USER 3, on the standard and enhanced front
panels. These are user-programmable and can be used for various applications such as performing an LED test, switching
setting groups, and invoking and scrolling though user-programmable displays.
The location of the control pushbuttons are shown in the following figures.
5
An additional four control pushbuttons are included on the standard faceplate when the G60 is ordered with the 12 user-
programmable pushbutton option.
5-110
CONTROL PUSHBUTTN 1 ID

CTRL PB 1
CONTROL PUSHBUTTON 1

FUNCTION: Disabled
CONTROL PUSHBUTTON 1

EVENTS: Disabled
Figure 5-43: Control pushbuttons (enhanced faceplate)
Figure 5-44: Control pushbuttons (standard faceplate)
Range: up to 20 alphanumeric characters
Range: Disabled, Enabled
Range: Disabled, Enabled
G60 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS