Activate Relay - GE G60 Instruction Manual
Generator protection system
Hide thumbs
Also See for G60:
- Instruction manual (780 pages) ,
- Communications manual (532 pages) ,
- Communications manual (526 pages)
Table of Contents
Advertisement
CHAPTER 3: INSTALLATION
ACTIVATE RELAY
Figure 3-53: Generator ground protection components
3
3.6 Activate relay
The relay is in the default "Not Programmed" state when it leaves the factory. When powered up successfully, the "Trouble"
LED is on and the "In Service" LED is off. The relay in the "Not Programmed" state blocks signaling of any output relay. These
conditions remain until the relay is explicitly put in the "Programmed" state.
G60 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
3-45
Advertisement
Table of Contents
