Mounting And Connecting The Hmi Device; Preparing For Installation; Checking The Package Contents - Siemens SIMATIC HMI KP400 Comfort Operating Instructions Manual

Mounting and connecting the HMI device

3.1

Preparing for installation

Select the mounting location of the HMI device
Points to observe when selecting the mounting location:
● Position the HMI device so that it is not subjected to direct sunlight.
● Position the HMI device such that it is ergonomically accessible for the operator.
Choose a suitable mounting height.
● Ensure that the HMI device air vents are not covered as a result of installation.
● Note the permitted mounting positions.
3.1.1

Checking the package contents

Check the package content for visible signs of transport damage and for completeness.
Note
Damaged parts
A damaged part will cause the HMI device to malfunction.
Do not install parts damaged during shipment. In the case of damaged parts, contact your
Siemens representative.
Check the scope of supply of the HMI device (see Scope of delivery (Page 15)).
Additional documents may be included in the delivery.
The documentation is part of the HMI device and is required for subsequent commissioning.
Keep all enclosed documentation for the entire service life of the HMI device. You must pass
along the enclosed documentation to any subsequent owner or user of the HMI device.
Make sure that every supplement to the documentation that you receive is stored together
with the operating instructions.
Comfort Panels
Operating Instructions, 07/2017, A5E36770603-AB
3
33