Msw6 - Citizen CT-D150 Command Reference Manual

4.2.6 MSW6

●MSW6-1:
Mode to use with the driver
[Outline] Selects the valid/invalid of mode to use with the driver
ON (1) OPERATION: FAULT signal is not output in the error condition to parallel port..
ASB is valid at power on. (Same behavior as GS a n command and n = 15)
OFF (0) OPERATION: FAULT signal is output in the error condition to parallel port..
ASB is ｉｎvalid at power on. (Same behavior as GS a n command and n = 0)
Remarks: Function below is added for the models after CT-S251/CT-S8xxII/CT-S6xxII.
Settings of automatic buffer clearing function at printer error are as follows.
●MSW6-2:
Character space mode
[Outline] Selects the valid/invalid of mode to have right space for each character
ON (1) OPERATION: Default of right space of each character is "0".
OFF (0) OPERATION: Default of right space of each character is "1".
The right vertical dot column in character composition matrix is repeated in the additional right space. In this mode,
●MSW6-3：
USB Power Save
Select the valid/invalid of USB Power save mode.
[Outline]
When printer is connected to the host through USB, if PC power is turned off or USB cable is
disconnected, printer enters special power save mode. This is USB Power save mode.
ON (1) OPERATION: When the condition is satisfied, printer enters the USB Power save mode.
OFF (0) OPERATION: Even the condition is satisfied, printer does not enter USB Power save mode.
Mode to use with the driver
・ON(1) OPERATION
・OFF(0) OPRATION
Character space mode
Same behavior as ESC SP n command and parameter n = 0.
number of columns for font B and C is decreased by 1 - 4.
USB Power Save
OFF(0)
Invalid
Automatic buffer clear at error detection is enabled.
Automatic buffer clear at error detection is disabled.
OFF(0)
Invalid
OFF(0) ON(1)
Invalid Valid
- 480 -
ON(1)
Valid
ON(1)
Valid