Msw3 - Citizen CT-D150 Command Reference Manual

4.2.3 MSW3

●MSW3-1:
Auto-cutter return
[Outline] Selects the return method from cutter lock error.
ON (1) OPERATION: Return by command.
OFF (0) OPERATION: Return with FEED switch.
●MSW3-2:
Clearing Cover Open Error
[Outline] Selects the method of clearing Cover Open error.
Operation at ON (1):
Operation at OFF (0):
●MSW3-2：
Paper end signal output at detecting paper near end
(Only for CT-S801(II)/CT-S851(II)/CT-S601(II)/CT-S651(II)/CT-S251/CT-D151/CT-E651)
[Outline]
Selects the Valid/Invalid of PE signal at detecting PNE
OPERATION at ON (1):
OPERATION at OFF (0):
Resum Cttr Err
After removing error cause, return with command <DLE ENQ n>.
After removing error cause, return by long pressing FEED SW (1 sec or longer).
Resum Open Err
When the printer detects that cover is closed and the printer receives a command <DLE+ENQ+n>, the
error is cleared.
When the printer detects that the cover is closed, it automatically clears the error.
PE output at PNE
When paper near end is detected, printer output the PE signal from parallel interface or USB interface. This
is same behavior of ESC ｃ 3 n command and n=15.
When paper near end is detected, printer does not output the PE signal from parallel interface or USB
interface. This is same behavior of ESC c 3 n and n=12.
OFF(0) ON(1)
Valid Invalid
(CT-S300 unique)
OFF(0) ON(1)
Close Command
OFF(0) ON(1)
Valid Invalid
- 470 -