Enabling/Disabling Fast Network Entry - Siemens RUGGEDCOM WIN5123 User Manual

Chapter 5
Setup and Configuration
Figure 58: Settings Screen
2. In the Allow NBR Scanning list, select Yes or No.
3. Click Apply.
Section 5.6

Enabling/Disabling Fast Network Entry

Enabling fast network entry (NE) upon handover (HO) failure will provide quick network entry in the event of
consecutive handover failure. This setting allows the device to disconnect from the serving base station and
perform full network entry to the target base station after a few consecutive handover failures.
CAUTION!
Data Loss Hazard - Risk of packet loss. Fast network entry eliminates handover and forces full network
entry. It is a debugging option and should not be enabled without specific instruction from Siemens.
Before enabling fast network entry, contact Customer Support to discuss and analyze the use of this
option.
To enable/disable fast network entry upon handover failure, do the following:
Navigate to WiMAX » Mobility » Settings. The Settings screen appears.
1.
Figure 59: Settings Screen
In the Fast NE upon HO failure list, select Enable or Disable.
2.
3. Click Apply.
66
RUGGEDCOM WIN
Enabling/Disabling Fast Network Entry
User Guide