Viewing And Clearing Rf Statistics - Siemens RUGGEDCOM WIN5123 User Manual

Chapter 3
Device Management
Parameter
Next re-authentication
Section 3.3.2

Viewing and Clearing RF Statistics

To view and clear RF statistics, do the following:
Navigate to Statistics » RF. The RF screen appears.
1.
Figure 13: RF Screen
2. View the RF statistics for the device:
Parameter
CPE Status
DL RSSI
DL CINR
DL CINR R3
MIMO mode
TX Power [dBm]
UL MCS
DL MCS
20
Description
Displays the time remaining until the next re-authentication.
Description
Synopsis: {Init, DL Synchronization, Handover DL acquisition, UL Acquisition, Ranging,
Handover ranging, Capabilities negotiation, Authorization, Registration, DHCP, TOD,
TFTP, Operational, Sleep, IDLE, Aborted}
Displays the current SS status.
Displays the downlink received signal strength, in dBm.
Displays the downlink carrier to interference and noise ratio, in dB.
Displays Displays R3 downlink carrier to interference and noise ratio, in dB.
Synopsis: {SISO, MIMO A, MIMO B}
Displays the SS Multiple-Input, Multiple-Output mode.
Displays the SS transmission power, in dBm.
Synopsis: {N/A, QPSK-CTC-1/2, QPSK-CTC-3/4, QAM16-CTC-1/2, QAM16-CTC-3/4,
QAM64-CTC-2/3, QAM64-CTC-3/4, QAM64-CTC-5/6}
Displays the uplink Modulation and Coding Scheme.
Synopsis: {N/A, QPSK-CTC-1/2, QPSK-CTC-3/4, QAM16-CTC-1/2, QAM16-CTC-3/4,
QAM64-CTC-2/3, QAM64-CTC-3/4, QAM64-CTC-5/6}
RUGGEDCOM WIN
User Guide
Viewing and Clearing RF Statistics