Table of Contents
Advertisement
RUGGEDCOM WIN
User Guide
Using WIN v5.0
This chapter describes how to use the RUGGEDCOM WIN interface.
CONTENTS
•
Section 2.1, "Configuring Network Parameters in Windows"
•
Section 2.2, "Logging In"
•
Section 2.3, "Logging Out"
•
Section 2.4, "Using the Web-based User Interface"
•
Section 2.5, "Accessing Developer Mode"
Section 2.1
Configuring Network Parameters in Windows
Network parameters in Microsoft Windows must be setup to allow a computer to connect to the RUGGEDCOM
WIN. For instructions on how to configure the network parameters for other operating systems, refer to the user
documentation for that operating system.
The device can be pre-configured in the lab, eliminating the need for configuration in the field. After installing a
pre-configured device, configure additional parameters remotely through the wireless link.
NOTE
The following procedure describes how to configure the parameters using Microsoft Windows 7.
To configure the network parameters in Windows, do the following:
1.
Make sure the PoE adapter is connected to the device.
2.
Connect the computer's Ethernet port to the PoE adapter's Ethernet port.
On the computer, click Start and select Control Panel.
3.
4.
In the Control Panel, select Network and Sharing Center.
5.
Select Local Area Connection. The Local Area Connections Status dialog box appears.
Configuring Network Parameters in Windows
Chapter 2
Using WIN v5.0
9
Hide quick links:
Advertisement
Table of Contents
