Table of Contents
Advertisement
RUGGEDCOM WIN
User Guide
Setup and Configuration
This chapter describes how to set up and configure the device for use on a network using the various features
available in the RUGGEDCOM WIN.
CONTENTS
•
Section 5.1, "Quick Configuration"
•
Section 5.2, "Managing Connectivity with Base Stations"
•
Section 5.3, "Managing Connections to Specific Base Stations"
•
Section 5.4, "Enabling/Disabling the GPS"
•
Section 5.5, "Configuring Neighbor Scanning"
•
Section 5.6, "Enabling/Disabling Fast Network Entry"
•
Section 5.7, "Configuring Scan Duration"
•
Section 5.8, "Configuring Failover BS Support"
•
Section 5.9, "Configuring the LAN Gateway"
•
Section 5.10, "Configuring the Network Interface Protocol (NIP)"
•
Section 5.11, "Configuring a Backhaul Subscriber Station"
•
Section 5.12, "Managing SNMP"
•
Section 5.13, "Configuring DSCP Marking"
•
Section 5.14, "Configuring Network IP Addresses"
•
Section 5.15, "Configuring the Management VLAN"
•
Section 5.16, "Configuring VLAN Tagging"
•
Section 5.17, "Managing MAC Addresses"
•
Section 5.18, "Configuring the WiMAX Radio"
•
Section 5.19, "Managing WiMAX Authentication"
Section 5.1
Quick Configuration
This section describes how to configure the initial device settings. This section describes just the minimal settings
required to connect the device to the network. After installing the minimally configured device, configure
additional parameters remotely through the wireless link.
To configure the initial settings, do the following:
Quick Configuration
Chapter 5
Setup and Configuration
51
Hide quick links:
Advertisement
Table of Contents
