Configuring The Primary Software Version - Siemens RUGGEDCOM WIN5123 User Manual

RUGGEDCOM WIN
User Guide
Figure 18: SW Properties Screen
Click Run Secondary. The device reboots, and runs the Secondary software image.
2.
Section 3.4.5

Configuring the Primary Software Version

To configure the currently running software image as the Primary software image (and switch the designation
from being the Secondary image), do the following:
Navigate to Management » SW Upgrade. The SW Properties screen appears.
1.
Figure 19: SW Properties Screen
2. Click Set as Primary.
Configuring the Primary Software Version
Chapter 3
Device Management
27