15. See Figure 14. Disconnect
the reduced lamp power
(dimmer) circuit connector A
from connector PL49 behind
the reduced lamp power
relay B on the main PCB.
16. See Figure 15. Cut the cable
tie (arrowed) on the ballast
fan leads.
17. See Figure 16. Lift the ballast
out of the base of the fixture
and set aside for possible
return to Martin under the
buy-back scheme (see
"Introduction" on page 1).
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 9 of 34
A
B
Figure 14
Figure 15
Figure 16