Martin MAC 2000 Wash Installation Manual page 26

63. See Figure 58. Hold the new
rear lampholder assembly
(P/N 55205111) supplied in
the Upgrade Kit up to the
back of the head and thread
the lamp leads behind the
rear lampholder plate
towards the lampholder
terminals. You may need to
release and remove the rear
lampholder plate temporarily
(as shown in the photo) to
make it easier to pass the
leads behind it.
64. See Figure 59. Clamp the
lamp leads into the
lampholder terminals A.
Fasten the lampholder
ground lead B to the head
re-using the original screw in
the same hole as the original
lead. Pull the lamp leads
towards the ignitor to
eliminate any slack in the
lampholder housing, but
make sure they are not
kinked or under tension.
Clamp the lamp leads in
place by applying the
push-on locking washer E
supplied with the Upgrade Kit
(P/N 08074402) on the lamp
lead clamp C. Install the
lampholder/rear cover
assembly on its mounting pillars D in the back of the head, re-using the original screws. Apply
Loctite 243 on their threads before tightening.
65. See Figure 60. Pull the lamp
leads back through the fixture
towards the ignitor leaving
only enough slack as is
necessary to open the rear
lamp housing cover.
Important! Leave as little slack as possible
in the lamp leads in the lamp
housing.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 26 of 34
Figure 58
D
A
Figure 59
Figure 60
C
D
B
A
E