Martin MAC 2000 Wash Installation Manual page 12

24. See Figure 22. Remove the
two Torx 20 screws
(P/N 08070701) arrowed
from the chassis facing the
main PCB, noting that a
ground (earth) lead is
fastened to one of the
screws.
25. See Figure 23. Fasten the
remote lamp on/off
opto-switch A to the base as
shown, re-using the original 2
screws and re-installing the
ground lead on the screw
where it was originally
located. A pair of leads with
connectors is supplied
installed on the remote lamp
on/off opto-switch. Both
connectors are marked LA.
See Figure 23. One
connector is installed at B on
the remote lamp on/off
opto-switch PCB. Route the
two leads alongside the
ballast wiring harness C over
to the ballast
26. See Figure 24. A jumper will
normally be fitted on the upper
low-voltage multi-connector
X301 (arrowed) on the ballast
PCB. Remove the jumper and
connect the pair of leads from
the remote lamp on/off
opto-switch to connector X301
as shown in Figure 24.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 12 of 34
Figure 22
A
Figure 23
Figure 24
C
B