66. See Figure 61. Fasten the
ignitor in its mounting bracket
re-using the original four
screws. Connect the ignitor
input connector. Secure
wiring with cable ties.
Important! Pull the lamp leads back
towards the ignitor so that the
only place where there is slack
in the leads is next to the
ignitor, as shown in Figure 61.
67. See Figure 62. Secure the
lamp leads with cable ties.
68. See Figure 63. Replace the
thermoswitches (arrowed) in
both sides of the head with
the two new thermoswitches
(P/N 05040023) supplied in
the Upgrade Kit, re-using the
existing screws.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 27 of 34
Figure 61
Figure 62
Figure 63