Martin MAC 2000 Wash Installation Manual page 16

35. See Figure 33. Use a cable
tie to fasten the ballast wiring
harness in its sleeve along
the side panel and well away
from all moving parts.
36. See Figure 34. The
low-voltage leads from the
remote lamp on/off
opto-switch PCB to the
ballast and from the reduced
lamp power circuit on the
main PCB to the ballast must
also be secured. Use cable
ties to fasten them to the
main ballast output cable
sleeve as shown in the
photo.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 16 of 34
Figure 33
Figure 34