Martin MAC 2000 Wash Installation Manual page 15

33. See Figure 31. Still working
with the ballast wiring
harness from the mains filter,
connect the double spade
connector with the blue leads
A to connector J8 beside the
lamp on/off relay, and
connect the double spade
connector with the brown
leads B to connector J5.
make sure that the double
spade connectors will not be
trapped or squeezed when
you close the PCB side
cover.
34. You are now left with one free
blue and one free brown lead
(C in Figure 31) connected to
the double spade connectors
you have just installed. See
Figure 32. Connect the free
blue lead and the free brown
lead to spade connectors
PL1 and PL2 (arrowed) on
the remote lamp on/off
opto-switch PCB you
installed in step 25. (photo
shows PCB before
installation). Polarity is not
important.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 15 of 34
C
B
A
A
Figure 31
Figure 32
B