Martin MAC 2000 Wash Installation Manual page 11

21. When you have completed
step 20. the fixture should
look as shown in Figure 19
with the relocated mains
input cable ground lead
(arrowed) fastened to the
base plate and trailing back
towards the XLR connectors.
22. See Figure 20. Place the new
ballast loosely in the base
and check that it will not foul
any wiring or other
component when installed.
Adjust wiring or components
if necessary, Do not fasten
the ballast to the fixture yet
because you must make
electrical connections first.
23. See Figure 21. An
opto-switch for the remote
lamp on/off circuit is supplied
with the Upgrade Kit (see "J"
in Table 1).
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 11 of 34
Figure 19
Figure 20
Figure 21