Martin MAC 2000 Wash Installation Manual page 13

27. See Figure 25. Connect the
reduced lamp power
(dimmer) circuit leads
supplied with the Upgrade Kit
(P/N 11730006, see "K" in
Table 1) to the lower
low-voltage multi-connector
X200 (arrowed) on the ballast
PCB.
28. See Figure 26. Route the
reduced lamp power
(dimmer) circuit leads
alongside the ballast wiring
harness over to the main
PCB and plug them into
connector PL49 A behind the
reduced lamp power relay B
on the main PCB.
29. See Figure 27. Connect the
blue lead and black lead from
the ignitor (starter) to the
spade connectors (arrowed) in
the base of the new ballast.
Polarity is not important – the
blue and black leads are
interchangeable.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 13 of 34
Figure 25
A
B
Figure 26
Figure 27