Martin MAC 2000 Wash Installation Manual page 17

37. See Figure 35. Connect the
brown Live power input lead
on the mains filter to the
spade connector A above the
existing brown lead on the
power on/off switch. Connect
the blue Neutral power input
lead on the mains filter to the
spade connector B above the
existing blue lead on the
power on/off switch.
38. Check that the new ballast is
correctly positioned in the
base. Lay the fixture on its
side and fasten the ballast
with the three Allen screws
(P/N 08111201, see "U" in
Table 1) supplied in the
Upgrade Kit, passing these
screws through the base in
the holes shown at A in
Figure 5 on page 6.
39. Reinstall the third screw from
the left in the bottom of the
base on the ballast side (see
Figure 4).
40. See Figure 36. Stand the
fixture upright again and
fasten the mains filter ground
lead to the base plate,
re-using the original screw in
the hole arrowed in Figure 36
and shown at D in Figure 18
on page 10.
41. Check that the wiring in the
base is correctly connected
with reference to "Schematic
wiring diagram" on page 4.
Check that all wiring is held
securely away from moving
parts. Attach wiring with extra
cable ties if necessary.
42. Reinstall the base side
covers shown in Figure 7 on
page 6. A new base cover A (P/N 55205504) for the main PCB side of the base and a new base
cover B (P/N 55205505) for the ballast side of the base are supplied in the Upgrade Kit. Fasten the
new covers' ground leads to the base as shown in Figure 2 on page 5 and fasten the covers to the
base re-using the original eight PZ2 screws (P/N 08070502).
You will need to open the ballast side covers again for final safety testing after all work has been
completed. Closing the base covers at this point will ensure that no screws or other items fall into the
base while you work on the head.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 17 of 34
A B
Figure 35
Figure 36