Martin MAC 2000 Wash Installation Manual page 22

54. See Figure 49. Cut the cable
ties holding the ignitor wiring.
55. See Figure 50. Release the 4
quarter-turn screws (A) in the
rear lamp housing cover.
Open the cover and remove
the lamp. Remove the two
Torx 20 cover retaining
screws (B) to release the
lampholder/rear cover
assembly and let it hang from
the lamp leads and ground
lead (the photo shows the
lamp leads already released
from their terminals, but you
will release them in the next
step). Keep the rear cover
retaining screws for re-use.
56. See Figure 51. Unscrew the
lamp lead clamp screws A
and release the leads from
their terminals in the
lampholder. Unscrew and
release the lampholder
ground lead B. Release the
lamp lead clamp C.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 22 of 34
Figure 49
A
A
Figure 50
A
Figure 51
A
A
B
C
B
A