Martin MAC 2000 Wash Installation Manual page 7

9. See Figure 8. Lift the ballast
up slightly and disconnect
the two ignitor leads (one
blue, one black) from their
spade connectors A. Then
disconnect the reduced lamp
power (dimmer) circuit
connector from connector
X200 B.
NB: Figure 8 shows the
ballast completely removed
from the fixture to make it
easier to see the connectors.
10. See Figure 9. Cut cable ties if
necessary and disconnect
the mains power leads from
PL1, PL2 and PL3 on the
mains filter PCB (arrowed)
that is part of the ballast
assembly.
11. See Figure 10. Unlock the
pan lock and swing the head
around for access, then use
a wire-cutter to cut the cable
ties and release the ballast
wiring harness (arrowed) that
runs from the ballast to the
main PCB.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 7 of 34
A
A
B
Figure 8
Figure 9
Figure 10