Martin MAC 2000 Wash Installation Manual page 20

47. See Figure 43. Remove the
four screws (PZ2, P/N
08070404) that hold the CMY
module, disconnect the
module's multi-connectors
marked 16, 17, 18, 19, 20,
34, 41 and T and lift the
module out of the head. Keep
the screws for re-use during
re-installation. This module is
no longer required, as a new
CMY module is supplied in
the Upgrade Kit.
48. See Figure 44. Remove the
two retaining screws (PZ2,
P/N 08070404) from each
rear head side cover and
remove both rear side
covers. Keep the screws and
covers for re-use during
re-installation.
49. Remove the two retaining
screws (PZ2, P/N 08070404)
from the left-hand front head
side cover and remove the
cover. Keep the screws and
cover for re-use during
re-installation.
50. See Figure 45. We
recommend that you tape
loose wiring to each side of
the head temporarily to keep
it out of the way and avoid
damage.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 20 of 34
Figure 43
Figure 44
Figure 45