Martin MAC 2000 Wash Installation Manual page 6

5. Lay the fixture down carefully
on its side and remove the
screw third from the left
(arrowed, Torx 20, P/N
08190404) from the bottom of
the base on the ballast side.
Keep the screw for re-use
during installation.
6. See Figure 5. Use a 4 mm
Allen key to remove the three
ballast mounting screws A
from their holes (arrowed)
around the serial number label
in the base. In older fixtures,
you must also remove a fourth
ballast mounting screw B.
Throw these screws away
because three new ballast
mounting screws are provided
in the Upgrade Kit. When you
install the new ballast, you will
insert the new mounting
screws in the holes at A.
7. See Figure 6. Stand the fixture
up again. Remove the four
Allen screws (P/N 08111206)
A from the top corners of the
base panels on both sides of
the fixture. Remove the two
Allen screws (P/N 08111210)
B from the bottom corners of
the base panels on the ballast
side of the fixture and remove
the ballast side base cover B
completely. Keep the side
cover and all screws for
re-use.
8. See Figure 7. Loosen the
Allen screws (P/N 08111210)
C in the bottom corners of
the base panels on the main
PCB side of the fixture and
swing the main PCB side
base cover A open.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 6 of 34
Figure 4
A
C
A
A
A
Figure 5
Figure 6
Figure 7
B
A
A
B
B