Martin MAC 2000 Wash Installation Manual page 29

72. See Figure 66. Two new fans
(P/N 62222079) and eight
new mounting screws
(P/N 08070700) are supplied
in the Upgrade Kit. The new
screws are much shorter
than the fan mounting screws
you have just removed and
must be tightened on the
inner flanges (as shown at A)
of the fan housing, using a
screwdriver thin enough to
pass through the holes in the
outer flanges. Use the new
screws to install the 2 new
effects cooling fans in place
of the old ones. Install both
fans with their labels facing
inwards as shown in Figure
66 and install the wire
retaining clips
(P/N 13101010) supplied in
the Upgrade Kit as follows:
• one clip on the front top
mounting screw B of the
left-hand side fan, and
• the other wire retaining clip
on the rear top mounting
screw C of the right-hand
side fan.
MAC 2000 Wash XB Upgrade Kit Installation Guide – Page 29 of 34
B
B
C
Figure 66
A