Error Codes And Troubleshooting - CARDIOSTRONG CST-TX40E Assembly And Operating Instructions Manual

2.3

Error codes and troubleshooting

The treadmill was designed and produced in order to guarantee reliable and easy
handling. If, however, there are any problems, these steps will help you find the cause.
You can also try to turn it on and off. If the problem still cannot be solved, please
contact your contract partner and ask for technical customer service.
Problem: The scan lighting is weak and no other lights are on.
Solution: The equipment is in power saving mode. Hold the START button for two
seconds.
Problem: The console jumps or nothing turns on.
Solution: Check if the treadmill is correctly connected. Turn the power on and off. Make
sure that the safety key is correctly inserted. Check all cable harness connections for
correct connection. If the problem still exists, contact your contract partner.
Problem: The belt from the treadmill does not stay in the middle when the equipment
is being used.
Solution: Check first if the treadmill stands on a levelled floor. Then have a look at the
instructions for tensioning and aligning the belt.
Problem: The treadmill motor seems to be overloaded or E1 is displayed after a few
minutes.
Solution: The silicone which was used for lubricating and which was given on the deck
and the belt, is worn and the belt needs to be lubricated with silicone spray.
Problem: The band slips while using.
Solution: The belt may needs to be tensed after a certain time of use. Have a look at
the instructions for belt tensioning and aligning.
Problem: The heart rate is irregular or is not detected at all.
Solution: Check whether your hands are wet (Aloe Vera helps). Check if all plugs at
the back of the console are correctly connected and no cables are damaged. When
you wear a chest strap, make sure that the batteries are loaded and electrodes are
moistened and that the chest strap is worn correctly.
Problem: Silicone sign lights up on the display.
Solution: Lubricate the belt with 100% pure silicone. Then simultaneously hold the
Speed DOWN button and the incline button until the light goes off.
TX40e
12