CARDIOSTRONG CST-TX40E Assembly And Operating Instructions Manual page 13

Problem: E1 appears on the display after you have used the treadmill for a few minutes.
Solution: If E1 is displayed, remove the security key and plug it back into the treadmill
to restart it. If E1 is still displayed, please check the following:
1. Check if all cable connections are correctly connected.
2. The treadmill does not move after you press START and E1 is displayed. Check if any
part is stuck.
3. The treadmill runs for a few minutes after you press START, but then it stops. Check
if the sensor (near the flywheel of the front wheel) is loose or broken.
4. Check if the cables connected to the motor are fixed and secure.
5. Please contact your contract partner and ask for technical customer service if E1
cannot be repaired.
Problem: E2 appears on the display after you have used the treadmill for a few minutes.
Solution:
1. Check if the console IC chip is attached correctly. In order to solve the problem,
connect the console IC chip again.
2. Check if the console IC chip is bent or not connected correctly. In order to solve the
problem, connect the console IC chip again.
3. Please contact your contract partner and ask for technical customer service.
Problem: E6/E7 appears on the display after you have used the treadmill for a few
minutes.
Solution: If E6/E7 is displayed, remove the security key and plug it back into the
treadmill to restart it.
1. Reset the incline value:
(1) If the position of the incline is under the medium level, press MODE and INCLINE
UP. Hold both buttons to increase the incline. Release both buttons once the incline
position has reached the medium level.
(2) If the position of the incline is above the medium level, press MODE and INCLINE
DOWN. Hold both buttons to decrease the incline. Release both buttons once the
incline position has reached the medium level. Try this for a few minutes. If the
incline does not move, please contact your contract partner. Once the incline is at the
medium level, turn off the power and restart the machine. Pay attention to see if E6/
E7 is displayed still. If it is, please contact your contract partner and ask for technical
customer service.
2. Check if the red and white incline cables are correctly connected to the MCB.
3. If the steps above do not help, please contact your contract partner and ask for
technical customer service.
13