Attaching Markers - Omron NX1P2 series User Manual

To remove an End Plate 1) insert the tip of a flat-blade screwdriver into groove "a" and 2) use "b" as
a fulcrum and lift the end of the screwdriver, as shown in the following diagram.
2)
Flat-blade screwdriver
5-3-7

Attaching Markers

Markers can be attached to NX Units and their terminal blocks to identify them.
The plastic markers made by OMRON are installed for the factory setting. The ID information can be
written on them.
Commercially available markers can also be installed.
Replace the markers made by OMRON if you use commercially available markers now.
Markers
The marker attachment locations on the NX Units depend on the type of external connection terminals.
Refer to the user's manual for the NX Units that you will use for the marker attachment locations.
 Installation Method
Insert the protrusions on the markers into the marker attachment locations on the NX Units and ter-
minal blocks on NX Units.
Marker
NX-series NX1P2 CPU Unit Hardware User's Manual (W578)
b
a
1)
Marker attachment location
<Units>
Marker attachment location
Marker
<Terminal Block>
5 Installation and Wiring
5
5 - 25