Omron NX1P2 series User Manual page 187

5 Installation and Wiring
Removing a Terminal Block
1
Loosen the M3 screws on the right and left sides of the terminal block, and remove the terminal
block.
These screws are the self-raising screws, so the terminal block is raised when they are
loosened.
Loosen the right and left screws alternately if they are hard to loosen.
Input terminal block
M3
screw
5
M3 screw
Output terminal
block
5 - 55
NX-series NX1P2 CPU Unit Hardware User's Manual (W578)