Attaching Markers - Omron sysmac NX Series User Manual

4-1-2

Attaching Markers

You can attach markers to the NX Units to identify them.
The plastic markers made by OMRON are installed for the factory setting. The ID information can be
written on them.
Commercially available markers can also be installed.
Replace the markers made by OMRON if you use commercially available markers now.
A marker that is attached
to the NX Unit
A marker that is attached
to the terminal block
The marker attachment locations vary depending on the type of the external connection terminals on
the NX Units.
Refer to the user's manual for the NX Units that you use for the external connection terminals.
External connection terminals on NX Units Marker attachment location
Screwless clamping terminal block
M3 screw terminal block
MIL connector
Fujitsu/OTAX connector
Marker Installation Method
Insert the protrusions on the markers into the marker attachment locations.
Marker attachment
location
Marker
NX Unit
NX-series System Units User's Manual (W523)
NX Unit and terminal block
NX Unit only
Marker attachment
location
Marker
Screwless clamping
terminal block
4 Installation and Wiring
Marker attachment
location
Marker
Terminal
block cover
M3 screw
terminal block
4
4-5