RIGOL
2. Limit Measurement
The Limit test function enables you to perform pass/fail testing to upper and lower
limits that you specify. You can set the upper and lower limits to any value between
0 and ±120% of the highest range, for the present function. The upper limit you
select must be a more positive number than the lower limit.
Press
Limit , enter the menu shown below:
Table 2-12 Limit Measurement Menu Function Explanation
Function Menu
Settings
High
Low
The parameters value scope of Limit function:
(1). The limit value scope is 0%~±120% of the current measurement range.
(2). The upper limit value should be always bigger than the lower limit value.
2-16
Figure 2-15
Set the desired Upper limit.
Set the desired Lower limit.
Save all changes, back to a higher level menu.
© Copyright RIGOL Technologies, Inc. 2007.
User Manual for DM3000 Series
Explanation